Talaria Komodo Turn Signal Install Instructions

Make sure bike is off and key is removed from ignition. Unplug battery.
Disconnect stock rear tail light and remove from bike
Remove screws from stock tail light and install into the provided tail light bracket.

4. Feed the tail light connectors through the hole in the mudguard. Attach tail light and bracket to the bike.

5. Insert the pins to the connector according to the diagram bellow:

6. Plug in adapter plug into the tail light connector and plug in connectors according to the matching connectors

7. Route front turn signal connectors through the inside of the frame to under the key ignition

8. Route the indicator switch and wire through the frame to under the ignition plate. Remove the key ignition cover and route the switch through the top of the ignition cover with the wire coming out from the top.

9. Remove left side grip slide turn signal indicator onto the handlebar, make sure to leave enough slack in wire to allow the handlebars to turn freely.

*It may help to clear up space by moving the regen switch over to the right side of the handlebar*

10. Mount the included front turn signal brackets on the forks

*Needs to be mounted right bellow TOP triple clamp*

11. On the front turn signals, remove the nut, keeping the spacer on the turn signal. Feed wire though the hole in the bracket and screw nut on, tighten into place.

12. Route the wires through the back of the front plate to under the ignition. Pin the connector according to the diagram bellow: Red on the right and black on the left